Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There is stack of two Catalyst 3750E-24T and of two Catalyst 3750E-12S. On the two Catalyst 3750E-24T configured Cross-stack Etherchannel (interface Port-channel1) is bundling interfaces GigabitEthernet 1/0/1 and GigabitEthernet 2/0/1 in the mode 'on...
It is not helping! =). I tested Cross-Stack Etherchannel in both mode. Result was the same. I changed even Stack Master (from switch 1 to 2) and after election the bundled port Gi1/0/1 is displayed in the Etherchannel only through 'remote command 1 s...
>Yes, in fact we had recently upgraded to the 12.2(40)SE >>Have you seen the same problem?Yes it is.http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=LAN%2C%20Switching%20and%20Routing&CommCmd=MB%3Fcmd%3D...
