Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.I have a problem with NAT configuration. It is somewhat similar to 'NAT-on-a-stick' situation, with NATing on a loopback interface.I have a simple network with 2 hosts connected to 2 Fastethernet ports of a router, and one loopback interface on...
Unfortunatelly, I can't get this info for working condition on 6500, because I can't put same acl on same interface again (it was put accidentaly).From 2600 I can get working info, but I don't know how relevant it is.And non working info from 6500 I ...
One update of this info.On 6500, with this config, in one moment I have accidentally put on fa0/1 acl that denied all traffic except traffic from nat pool ip, and in that moment nat worked. When I removed it, or put permit any at the end, it didn't w...
As I said, real situation is not this simple. On that device there are many many interfaces, vlan interfaces, and much much traffic. Traffic from Fa0/0 from image is, let's say tiny, comparing to the traffic on other interfaces, and putting 'ip nat o...
Hi.I have just seen Your post. Thank You for sugestion. I think of this one too, but haven't tried it yet.I hope You will see my other post, I attached configuration I tried on 2600 router, and this one worked fine, but problem still not solved, beca...
Hi.I have tried little bit different config on test platform with router 2600, and this one worked perfectly.But when I put configuration on 6500, where it should be, nothing worked again. I know 2600 wouldn't be exactly nice test platform for someth...
