Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to remove my passive unit from my current active/passive setup. Other than just unplugging the FOLink and turning off the unit is there a safe method of removing it from the pair? Keep in mind this is a production firewall housing ...
I am trying to authenticate from a DMZ host to an active directory server on the Inside. I have posted a clean configuration with everything I think that you will need to know. Basically I have opened all the correct ports for domain authentication (...
Hello.Basically this is my setup.DMZ - 10.10.xxx.xxxPrivate - 192.168.xx.xxxOutside - 66.38.xxx.xxxI have my new domain controller on the Private network where I house my database servers. I am trying to get my webservers from DMZ to authenticate thr...
Hello,I was looking around and I cant find anywhere that outlines how to load a new OS. I have the .bin file, could someone please provide me with a link or the commands to do this.Thanks in advance,Chris
Hello,Just a quick question, the time on my ASA 5520 is off by a few hours, so I would like to change it. The firewall is in a production environment, I cant reboot it, I was just wondering if there are adverse effects of changing the clock on the AS...
Thanks a lot, after issuing the 'no failover' command am I am assuming you mean to remove the actual lines that reference the failover setup when you say "clear configure failover".Thanks a lot!
Ok I have about 4 hours until my deadline now. If I load up my primary unit and enter the command "no failover" will that be adequate to remove the secondary unit from the mix without having my primary mess up?I have set up active/passive a few times...
Jorje,Its working! Not sure why but I just had to reboot the server that was trying to authenticate (I assume something was cached even though I tried flushing the DNS before that).Thank you very much for all your help with this, no way I could have ...
No luck again, I think that I may have found the command in the configuration that is messing things up thoughnat (inside) 1 192.168.xxx.0 255.255.255.0global (DMZ) 1 interfaceSo all addresses on my Inside subnet are PATd to the interface IP of my DM...
