Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 50 users in my LAN with VPN Client installed. Remote Site is connected to Central Site through INTERNET.I have onely one Public IP available to me. I want to go for PAT (NAT) at remote site to connect to the Central Site Servers.I want to have...
Hi,I would like to know the actual impact of loopback command in interface mode.I have two router connected over WAN link of 64 kbps capacity.R1---modem---PSTNmodem--------PSTmodem----modem----R2At router end we have V.35 Interface and modem side G.7...
Hi,I have two different L3 Switches (4006 and 4003) connected via trunk. Assumeing one PC is connected to each switch.Now I would like to control TCP, UDP, ICMP traffic between these two PCs which are under same VLAN.Please suggest a solution/recomm...
Hi,I need to have 10 Mbps WAN link between two locations. As of now my service procider can give only 2 Mbps links only. So I want to get 5 links and bundle all these 5 links to get 10 Mbps Bandwidth. Is this (bundeling 5 links) is possible on cisco ...
Thnaks for the info.But our client requirement is to have VPN tunnel up to the client end from server. Can we do it? If so plz let me know how to do it.According to client requirement there will be 50 VPN Tunnels to the central server one from each c...
From URL you have suggested, I understand that if the loopback command is configured on a router interface, then it will be seen only on that router interface only as (looped). Is it correct? orcan we see looped on remote end router interface also ?R...
Fine. I had already gone through the URL you referred. My doubt is how to use it? For example if I give loop at any one modem we can see in the router interface statistics as loops. But it is not he same in case of this command. Please let me know ho...
