About rmlounsbury

rmlounsbury · 07-12-2007

Before I get into the details let me give the details of my modest little network:I have 1 Cisco 3750 (SMI) serving as my core switch/router. This switch has InterVLAN Routing setup including the SVI's for 4 subnets (10.1.10.1 - .40.1). My access lay...

rmlounsbury · 07-12-2007

And right you are... No NAT Table edit function. I did go through and reset my switches and re-programmed them with just enough information to active IntraVLAN Routing and the default route to the Linksys. After doing that all my computers on the VLA...

rmlounsbury · 07-12-2007

Gotcha. I'm trying to find where I can edit the NAT table on the linksys device. So far all I can find is a One-to-One NAT function but that isn't what I want.Will update when I figure out where Linksys stashed the NAT Table.

rmlounsbury · 07-12-2007

The linksys routing table has 10.0.0.0 255.0.0.0 in its routing table. I was hoping to cover everything with a blanket route.I will need to double check my settings on that end. I should probably add each individual subnet on to the Linksys device an...

Member Since	‎04-24-2007 08:10 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4

User Statistics

User Activity

VLAN to WAN Communication Issue

Re: VLAN to WAN Communication Issue

Re: VLAN to WAN Communication Issue

Re: VLAN to WAN Communication Issue