Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
When I programmatically - from a controller - try to get "lldp neighbors" using NETCONF, on the Cisco device, I see the following error (highlighted) for a neighbor Arista device. A neighbor Cisco device does not result in this error: 8:37:1...
Ok, I know the telco are hard to deal with out there. So I can feel your pain and frustration.Just remember ISDN is like a phone call and the Telco has to get the call routed to the far end.Someone in Telco land out there has to be able to trace this...
hello,Everyone that has replied is exactly right.I just found this on googlehttp://en.wikipedia.org/wiki/Q.9310x2 2 No route to specified transit network (Transit Network Identity) what this mean in plan English is the Telco doesn't know how/where to...
One other thing to chk is In your dialer map, is dialing a 01 correct as usually it's just a 1 or an access code ive never seen anyone dial with a 0 first unless its an international number.If that is correct then get telco to trace you call. Also i...
Hello,The BEFSX41 should get a valid ip from the DSL/cable MODEM every time it boots up. With just straight PC traffic there very simple to set up. I'm not sure what the BEFSX41 will do with ip phones and tunnels ETC though of if its even supporte...
