Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear ALL,I new with CEMoIP, now i have problem with our connection CEMoiP. The controller where i terminate the E1 PRI have some error (slip error)Can we get advise from this forum. All Clocking i have try but the result still same.FYI i use "NM-CEM-...
Hi,I new in this forum, i have a problem on implement TDMoIP. FYI, i have infra with cisco product. When i run TDMoIP i have a problem with the stability of E1 that connect to our router E1 AS 5300. Is there any special config on cisco device to conf...
Sorry sir, L2TPv3 means (Layer 2 Tunnel Protocol version 3). Can u explained detail about that.... Is it complusory to run this on network to run TDMoIP ?I'm using other product.
TDMoIP devices are (IP-MUX --> RAD) & (T-Marc -->Telco). On the TDMoIP box, yes has a packet lost, but on FastE that connected to TDMoIP that no packect loss.The AS 5300 reported e1 alarms. The clocking are from telco.
We have problem at AS 5300 where we terminated our E1 PRI after go through TDMoIP over our network. The E1 PRI at AS 5300 not stable, it will be up and down. The down time only a few milisecond .Here we attached the diagram.Thanks for support us.
