Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I am experiencieng MSTP protocol abnormality in integrating 3rd party SW units connected to Cisco7609-1 and Cisco7609-2. Cisco 7609-1 is the bridge root since spanning tree priority is set to lowest value than Cisco 7609-2. The two SWU are co...
Here's the configuration:interface GigabitEthernet1/23 description test switchport switchport access vlan 140 switchport mode access switchport nonegotiate speed 1000 duplex full no cdp enable spanning-tree portfastThe cable is straight and in good c...
I am tasked to make a local connectivity within one site. The interface vlan was associated to specific VRF. This Interface Vlan is being implemented with HSRP. From the router, i only got successful ping to HSRP gateway. Ping to host elements are no...
Dear Guisseppe,Cisco7609 supported MST and terms of configuration, both Cisco 7609 and third party SWU are within the same region and all MSTP parameters are the same.But the problem is still there. Is there any other parameters that i need to look a...
Dear Guiseppe,Thanks for your reply. MST are supported on both C7609 using IOS c7600rsp72043-advipservicesk9-mz.122-33.SRC.bin.Third party switches supported iee802.1s mstp implmentation.
