Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 1750 routers back to back with two point to point T1's and OSPF running. Why would one of the T1's (either) (show interface S0 or S1)intermittantly show either no transmit or no receive? All stats in service-module look clean. See attach...
Nice!... Thank you Wilson. I'm just a "novice" Cisco technician,... Yeah, the site is a tough one on us to get in and out, so this one is already on the printer and now in my bag of tricks. Thanks, Pete
Hi,I'll take a look at the ip route next time I get to the site (no remote access). Thanks for your suggestion on CEF. I think that's the road I was heading down!. You may of confirmed it for me. Thank you, Pete
Thank you for you input. I do have a "future" multilink configuration that I'm going to install in the future. Right now, the "remote" side might as well be on the moon. It's in a high security area that takes an act of congress to physically acce...
Hi, Attached are the router configs. No, CEF is not running. Ah, the data that these routers pass is VoIP traffic from Nortel 9150 boxes. Lots of UDP and small packets. Interesting enough, This has been in for the last 4 years, virtually undistur...
