Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Can some one please explain me what is the use of different VTEP Pool (IP) in each multipod site.as i know leaf and spine get tep IP addresses in each pod from Seed pod (Primary POD) then what is the use of different TEP pool in all multipod ...
Hello, can some please help me to understand below questions.While creating the subnet under Bridge domain we have three scopes1> Private to VRF.2> advertise externally.3> shared between VRF.A> My 1st question is if i select private to VRF then, will...
Hi All, I am new in ACI, i was just checking whether we can check teachablety between end point to end point through ping, i know we can check it using destination IP & through source gateway IP, but how can we ping from end point to end point IP.Th...
Hi,i am using cisco 1905 series router in my office, i have two internet links in that router.The problem is that i am not able to configure IP sla in that router.Below are model and IOS image of that router.Model- CISCO1905/K9IOS: c1900-universalk9-...
@RedNectar Thanks for the information. I understood that all the uplinks has 40g or 100g ports and will not support 10g or 25g interface connecting tp APIC.Again thanks for clearing my doubt. RegardsDeepak
Hi Sergiu,Thanks for you reply but still i am bit confused as you said (however, the IP address assigned is from the VTEP Pool configured for Pod2) you mean to say that leaf and spine in another pods get IP addresses from Pod 2 Tep pool? Can you plea...
Thanks Ram for your time and help, I tried given command through CLI, I am able to ping from BD gateway to destinations ip but not from EP IP. Any suggestions or documents on this? Regards Deepak
