Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2601 WLC and 4 (lightweight) APs connected to it with "no security or encryption. I have about 30 client devices that have old b/g cards in them. When I use any other device that is less than 5 years old I have no problems. However the ol...
I have a problem where there are 60 buses associated to 1 AP. The bus pulls into the yard and associates with the first AP it see and that is ok. However, as the bus moves to the end of the yard 300 ft away from the 1st ap it will not associate wit...
I have 3 map backhaul and 1 rap as the root backhaul. why can I only see 1 root ap ssid broadcast even if I have all ap backhaul set to guest-mode(broadcast)ap1 is the root...
We are building a wireless mess for a bus garage and we speced cisco omni 5.0 dbi for the 802.11 a radio. however we plan to mount these from ceiling of the building. When the antenna came in they have a sticker on them that says do not hang upside ...
They are people counters for a transit bus. I know that the clients are sending data because if I switch the AP back to autonomous mode and remove the WLC from the configuraion it all works. Thanks
Here is the debug, the mac address in question is 00:60:b3:03:66:33=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2011.12.02 06:38:37 =~=~=~=~=~=~=~=~=~=~=~=*pemReceiveTask: Dec 02 09:30:21.771: 00:60:b3:03:66:33 Sent an XID frame*apfReceiveTask: Dec 02 10:10:42...
thanks, I have all data rates set to enable with 1.mbps set to mandatory. Remember the old clients will associate, but will not authenticate on a ssid that has no security or encrypetion.thanks
