Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am new to the Cisco Pix. We are in the process of implementing a new Pix 520. I was wondering how I can upload a policy from another Pix into this new one. Is it possible to upload all the ip address and route information as well? Thanks in adva...
I am having a problem with being able to ping and trace route out of our corporate office. Our setup is - point to point from corp (2501) to colocation (2621) via a T1 line. From 2621 router to ISP cloud through a cisco pix. Now for some reason I can...
I am new to cisco routers so please excuse the simple questions. I have managed to set up point to point from our corporate office to our colocation. We have a 2621 route at the colo and a 2501 router at our corp via a T1. It seems to me that the con...
Here is the sh int on all. The thing is serial0 is not being used. Since then i have cleared the counter to see if errors persist. it looks like ethernet0 still has alot of collisions though.Ethernet0 is up, line protocol is up Hardware is Lance, ad...
Here is the config for the 2621 router:Current configuration:!version 12.0service configservice timestamps debug uptimeservice timestamps log uptimeservice password-encryption!ip subnet-zeroip name-server 216.39.106.4!!!!interface FastEthernet0/0 ip ...
On the 2621 router both ethernet interfaces are running at full-duplex but on the 2501 router there is no option to enable full-duplex or even half-duplex. Does the 2501 have that feature?
