Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When we setup a connection between two hosts we receive the message "TCP checksum incorrect" , This is between a settop box on the outside and a server inside the firewall. This STB used to communicate with the server on port 443 which is NAT-en to ...
Last night I've upgraded a catlyst 6509 (non-redundant), during the upgrade I run into the problem that the 6509 only wants to boot from sup-bootflash, and that it took an old image from sup-bootflash.I deleted this old image and then the node came i...
The catalyst 6509 in our mediafarm is running an old release: s72033-pk9s-mz.122-18.SXD3.bin.This catalysts has a firewall module and a loadbalancer module in it.We run about 400Mbps multicast traffic in vlan550 for our TV service, this traffic shoul...
I'm receiving multicast traffic (400Mbps) on port 9/38 and sending it out on port gi9/48I'm trying to achieve that traffic will stay within the card without using the switchfabric, Am I succeeding in this, please see attached file
We receive syslog warnings that we run to the threshold for the maximum supported mpls routes in the CEF table, below some information.What is the impact/risc if the threshold is exceeded?What is the service impact when increasing the settings?What ...
Nikolavthanks,regards,Jack KwakmanTele2 Nederland B.VFrom: nkarpysh To: jkwakman Date: 03/14/2012 11:50 AMSubject: - Re: Configuration register is 0x2101 on supervisor720 HomeRe: Configuration register is 0x2101 on supervisor720 creat...
Is a reload of the entire box needed? do all line cards need a reboot also?or is it possible that we first do a reboot of the redundant supervisor and after that a switchover so it becomes active and next do reboot of the other supervisor?
Thanks very much, my upgrade in our lab succeededJack KwakmanTele2 Nederland B.VFrom: fadlouni To: "J.J.M Kwakman" Date: 02/11/2011 02:18 PMSubject: New message: "Upgrade 6509 with SLB and FSWM" jkwakman,A new message was posted in th...
