Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Summary:Under certain conditions you may find that the NM-CIDS bootloader has been changed by mistake to load from the "secondary" instead of the "primary" partition. This configuration change could have been made by mistake when booted into the boot...
Torsten,The things that could potentially cause the IPS to go into bypass which could in turn potentially cause the ASA's to failover are as follows:Configuration ChangesAuto UpdatesGlobal Correlation Updates (5 minute intervals)Anomaly DetectionAs a...
Moath,Just to confirm, did you follow the process outlined here to reset the password:http://www.cisco.com/en/US/docs/security/ips/6.2/installation/guide/hw_troubleshooting.html#wp1139641If you did not please try to follow the above to reset the pass...
M.K.Below is a URL that covers the setup process of configuring the ASA to send traffic to the AIP-SSM module.http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807335ca.shtmlBasically the commands from the ASA might loo...
Hello,The reason for the unknown device event is because MARS only supports Enterasys Dragon v 6.x as per the following URL:http://www.cisco.com/en/US/docs/security/security_management/cs-mars/6.0/compatibility/local_controller/dtlc60x.htmlThere was ...
