Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiAnother newbie question. I'm trying to add a site to site vpn between two pix 501's as well as the basic software access vpn to site 1. At present however I can't get the 2nd site to connect. This may be because they both go through separate router...
Hi I'm trying to enable split tunnelling but what appears to happen at the moment is that i can access the vpn. at that point i still have external internet access. When i actually connect to the server then i lose internet access. i've attached my ...
HiI have a very strange problem. One of my users pulled the power out of the cisco pix 501. It powered off and came back up again. Users can still connect to the vpn but split tunneling is no longer enabled. I have checked the entries and they are al...
Hi,I have several clients accessing their office via vpn, I wish to grant them access to the internet at the same time through their home internet connection.Is the easiest route to enable split tunnelling? I'm unsure what I need to add to the config...
Hi,I have the following setup;external ip router (internal ip 192.168.128.1) -----> (external ip pix 501 192.168.128.2) -----> (internal ip pix 501 192.168.1.1)webserver 192.168.1.2I'm having difficulty accessing the webserver from the internet. I ca...
Hi Mark, Have added that. Strangely it doesn't seem to show the crypto map outside_map 20 match address 101crypto map outside_map 20 set peer 83.166.180.99crypto map outside_map 20 set transform-set vpnsetcrypto map outside_map interface outsidein th...
Hi Mark I had wondered how they tied together!When I try to add that I get the following error:Dynamic map entry already in useERROR: Unable to initialized crypto map entryCommand failedthe entry I have on each pix is identical except instead of 20 I...
Hi Mark, I think I've got that sorted. I now get a MM_KEY_EXCHstate when i do a show crypto isakmp ...so i guess its not authenticating properly or the tunnel isn't being set up.. have i missed something ? do i need to declare access lists specifical...
