Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two sources multicasting for the same group. Network connectivity is as follows:source s1 (on vlan X) and s2 (on vlan Y)------multicast router------Receiver (on vlan Z)Receiver is using IGMP V2 to join the group. Given the fact that Multicast ...
I have following scenario:There are two cat6509 swtiches, lets say cat1 and cat2.Vlan 10 is configured on cat1 with layer 3 information and is functioning as gateway for vlan10. There is no physical access port on cat1 that is part of vlan10. There i...
Is it possible to configure Cisco 800 series router so that it does not include DHCP Option 51 (lease time) in its dhcp discover / request message? If yes, then what configuration is required?
Well, that's interesting. In my case, router is choosing only one stream. For the other stream, "show ip mroute" output indicates Incoming interface as Null. "show ip mroute active" only shows the first (active) stream.
If cat1 is in vtp transparent mode (with vtp pruning disabled) and if cat2 has vtp pruning enabled, then if cat2 prunes vlan10 (upon access ports failure), will vlan10 port suppose go into down status in this case?
