Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i am trying to configure something i call STATIC PAT HIGH AVAIABILIY.2 wan links are terminated on 2811 router. these are the nat outside interfaces. I have an application server on the private (inside) of my router which needs to be available thr...
i have an application/web server on my private subnet, to which clients from internet connect. i have 2 wan links , (1 E1 and 1 ADSL) terminating on my 2811.now i want to nat/pat client landing on my real IPs to be natted/patted to my server and the ...
hi,i have a single 2811 with 2 wan links first one is E1 on E1 controller and the second links is through a DSL modem to one of the ethernet ports on 2811. these 2 wan links are from 2 different ISPs. i have a webserver on my private network. what i ...
hi, i am hosting an application server at HO to which clients connect using the client application, using 2 ports.(8090,8092). We were using a DSL connection and eveyrthing was good. Now we bought an E1, terminated it on 2811 using e1 controler card....
hi, i am hosting an application server at HO to which clients connect using the client application, using 2 ports.(8090,8092). We were using a DSL connection and eveyrthing was good. Now we bought an E1, terminated it on 2811 using e1 controler card....
i am using both ISP links together , simultaneously.i have 2 default routes to the ISPs as well.ip route 0.0.0.0 0.0.0.0 interface isp1ip route 0.0.0.0 0.0.0.0 interface isp2looking forward to your reply,Many thanks,RAZA
have an application/web server on my private subnet, to which clients from internet connect. i have 2 wan links , (1 E1 and 1 ADSL) terminating on my 2811. now i want to nat/pat client landing on my real IPs to be natted/patted to my server and the r...
hi,i will look into disabling ip http server. when i try to issue another nat command for the same web server but from the 2nd wan link the first nat gets replaced.if a client is accessing the webserver uding the ip from wan link A and my default gat...
thanks for replying.but the problem persist as i cannot nat between 2 wan interface ip addresses to a single web server.i am using the following command for natting.ip nat inside source static tcp ( web server private ip) 80 int serial 0/0/0:2 80i ca...
well i am actually using the pptp vpn server on 1841.vpdn enable!vpdn-group 1! Default PPTP VPDN g accept-dialin protocol pptp virtual-template 1 local name cisco_pnsinterface Virtual-Template1 ip unnumbered FastEthernet0/0 no ip directed-broadcast...
