Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I'd like to ask whether someone knows how to configure the hardware client using CA?Normally when using pre-shared key, in the hardware client we only need to configure crypto ipsec client ezvpn <name> and specify the ezvpn group underneath....
Dear all,My question is: If you enable pptp from a MS WindowsXP client PC to a Cisco Router 12.3(10a) through vpdn dialin, could you authenticate and authorize from a radius server?The problem was each time I dialed from the PC, it would prompt an er...
Hi,Thanks very much for your reply. Indeed the EZVPN Server here I meant was any type of VPN devices including VPN concentrator. I've figured the problem out through the cisco.com and if the trustpoint is used between the hardware client and the EZVP...
Hi,Do you mean L2TP using IpSec as encryption method? WinXP could be assigned with preconfigured IPSec policies with local IP Security Policies on Local Computer from mmc. From Security methods tab, you can custom your esp transform set.Also you need...
Hi there,I think the problem might be caused by your NAT in the security appliance. When your defined VPN traffic went through your PIX, it was translated to another destination address thus it failed to meet your SAP_oasis.You need to user NAT 0 to ...
Hi Jean,Sure! Configuring outside NAT might be easier in security appliances. For outside NAT, you need to identify the nat command for outside NAT (the outside keyword).http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter0...
Dear Stefano,As you mentioned, you would hope to tunnel most of the local lan traffic through VPN but keep a certain amount of traffic destined to your printer within your local lan, why not exempt the printing traffic from the VPN interesting traffi...
