Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I asked yesterday about the to reserve some bandwidth to a specific ip on my router.the case is that we have a 2600 router with two fastethernet interfaces. connected to the ISP with 18M bandwidth and the other to the local network. We have 32 pub...
hii have a 2600 router with two fastethernet interfaces.Fas0/0 is connected to to the line from my ISP with 18M bandwidth.Fast0/1 is connected to the local network.we have 32 public ips.my question is "Can i split the 18M between ips, for example can...
hi all.i have the following scenario and i want to see if it doable or not..i have an 2600 router with two fastethernet interfaces.the Scenario:1- i want to connect Fast0/0 to the isp.2- i want to connect Fast0/1 to a network with two vlans, so i wan...
Hi.i have a 2600 router and i need to apply the vlan trunking on subinterfaces fastethernet 0/1.1 and 0/1.50.the configuration i tried are as followsRouter(config)#interface fast 0/0.1Router(config-subif)# encap?% Unrecognized commandthe sho versio...
hi all. i attached a figure that simply explain the network in my university..as you can see most of the IPs are assigned by DHCP and passed through the firewalls to the internet.the problem is that there are some public IPs we have and need to let t...
Hi.. thank you.it seems that the rate limit done all the work.i put two access groups one for the whole ips except the needed one and the other with the neede ip permited, also i configured two rate limit rules on the ISP interface. and it is done.wh...
Hi again.i did as you said. and the configuration are as follows.!class-map match-all class1 match access-group 101!!policy-map thaer class class1 bandwidth 5120 class class-default fair-queue!interface FastEthernet0/0 ip address y.y.y.y 255.2...
Ok..i think this ip is going to be used for some kind of video confrencing. it will be connected to one pc only.the other 17M will continue to serve the rest of the uneversity i worked in, i.e they are used on the firewalls we have.
thanx a lot.i have 32 public ips, and what i need exactly is to give one of those ips 2M bandwidth.and the other 31 ips, i really don't care about them.so i think i need to classify traffic and apply appropriate scheduling (QoS). but first i need to ...
