Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have problem with the ASA firewalls failover, when the ether channel between the layer 2 switches are pulled out, this triggers failover on the ASA, the ASA are Active/Standby. Please see the attached file for the real architecture this is in visio...
I have 16M flash memory in my Pix535, it is not adequate for the upgrade I wish to carry out even after deleting the PDM image. Can I upgrade the flash memory to 32M or 16 is the max memory I can have for Pix 535?Thanks
I want to upgrade a failover pix 535 bundle with 6.3(3) to 7.2 but I do not have enough memory in the flash, can anyone tell me how to go about this. Also the flash directory layout is not clear. If I do dir flash or sh flash, the name of the files a...
When I do sh run in Pix 535 6.3(3), the whole configuration scroll at once. I used to see the config page after page and using the space bar or enter key to scroll through, but now the whole config just scroll at once and put me at the bottom of the ...
No, it does not, when you set the security levels for sub interfaces, it does not have any interaction with the security level set on the physical interfaces. Routing is not possible between these interfaces unless you want this to happen then you us...
Make sure you save the existing activation key, this is what you need to use again when you upgrade the firewall to a newer IOS.Also be careful when you are upgrading from 6.0 to something like 7.2. There are 2 steps required to do this sucessfully. ...
I am really disappointed that non of the Cisco firewall guru can look into this problem and solve it. The problem has been outstanding for days now and no update yet. If this can not be looked into/solved please close the call.
Please see the link below:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml#pix_withoutHope it help.
Hi Vibhor,Thanks for your advice, from the output below, I carried out the task you asked me to perform, that worked you can see from my sh flash command that I have nothing in the pdm flash partition, after doing this I tried to copy the pix722.bin ...
