Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Last night I upgraded an ASA 5520 from 8.0.(4) to 8.2.1 it booted fine and seemed to pass traffic fine however any incoming static nat translations didnt work even though they showed up in the ASDM, should I have made any config changes prior to upgr...
Hi There, Im trying to enter a static route on a 3750 so I put in the route using the #ip route command but when i do a #show ip route static its not there , any suggestions
Hi There I am currenlty trying to apply a basic route map to an interface on a 3750. I set the sdm prefer routing command and rebooted the switch.I now have number of IPv4 policy based routing aces: 512 in the #sh sdm but I still dont have access to ...
Its unclear from my post but I am actually in config mode and the router accepts the command without any errors it just doesnt show up in the sh ip route
