Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For this question lets say that I have a B200M5 with a 1440 VIC connected to a 2304 FE. I know the backplane between the blade and the FE is 40Gbps (I think 4x10Gbps in a Po).Let's say I create a service profile with 3 vNICs (mgmt, data1, data2). I k...
I'm I reading this correctly in that the 6332-16UP does not have an option to purchase licenses for network like the 6332 does?Table 10 Port License PIDsProduct ID (PID) DescriptionLicenses for 6332UCS-LIC-6300-40G 3rd Gen FI Per port license to conn...
I'm trying to test the RAM in one of our blades using the Diag ISO https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/ucs_diagnostics/b_UCS_Blade_Server_Diagnostics_User_Guide-2-0/b_UCS_Blade_Server_Diagnostics_User_Guide-2-0_chapter_01.h...
Is there any rhyme or reason why the PSS SN2Info API is constantly timing out with a "504 Gateway Timeout" error? This occurs with all queries, be it a single serial or 75 at once, it makes no difference. Then when looking in the API console the plat...
I know it's a bit late but I just ran into this as well and figured I'd post how I found the leafs, containers, etc.I queried the capabilities off the C9200 I was testing on by using the followinghttps://10.0.0.2/restconf/data/netconf-state/capabilit...
I increased the RAM to 4GB and reinstalled from the ISO and now I get the web portal. Not sure if the third re-install or the extra RAM did it but I'm adding it to our backup jobs and leaving it alone.
