Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm having a problem that I can't figure out.To outline a simple setup of our configuration i looks like this:inside (sec. level 100)outside (sec. level 0)dmz (sec. level 20)Now, I've created a NAT excemt statement between the dmz and the inside n...
Hi,I was wondering if anyone of you knows if it is possible to do remote access ssl vpn configuration (both anyconnect and webvpn) using port 443, and have port 80 nat'ed and redirected into an internal web server, when I only have one public ip addr...
Hi,We're running an ASA 5510 (8.0) with SSL vpn for our clients (AnyConnect).Now, I've created 3 different profiles, and I have made it possible for the users to select the correct profile from a drop-down box in the AnyConnect client.My question is ...
Hi,We use Altiris between two VPN sites protected by a Cisco PIX (8.0) and an ASA (8.0).Altiris communicates some multicast traffic on tcp port 402, but this traffic get blocked by the firewalls with this message:%pix-6-106015: deny tcp (no connectio...
Hi,Our remote vpn clients cannot browse the web when connected.I do not want to enable split tunnelling, unless there is no other way to make this work.At the moment I've configured an ACL that allows all vpn client to "any" with http.It is an ASA 55...
Hi Jess,I just installed anyconnect mobile and got a trial license through anyconnect-beta@cisco.com but since then I am no longer able to allow WinCE in Secure Desktop. The option has just disappeared I will try without CSD now, but in the long run...
Hi Jon,Thanks for your reply.OK. I just thought that "any-traffic" from a lower sec. to a higher. didn't get through.I will follow your advice number 2.Thanks again.Rasmus
Hi there,Thanks for your answer. I discovered the error myself though. I had VLAN blocking enabled - so when I disabled it, it started to work.BR.Rasmus
Thanks for your reply.I use Microsoft IAS. But I have already created different AD groups and set up accordingly in the ASA. So it works when the users manually select which policy/profile to use during login.But now that I've got 3-4 different scena...
