Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having an issue with PBR that is driving me crazy. I have 2 outside connections with all traffic defaulting to the 1st outside connection. I'm trying to force 2 devices to send their traffic out the 2nd outside connection. One of the devices i...
I have 2 new Firepower devices in a HA Pair scenario, and I want to install an update on them through my FMC GUI. It states that reboots of the firewalls are necessary to complete the update. I have to assume that the reboots will not occur simulta...
ello, I have a new Firepower 1150 that has 2 internet connections. I'm using PBR to force certain traffic out the 2nd internet connection. Works great, except the problem I'm experiencing is that any traffic from the sources being forced out the 2n...
Hello all, new to the group. I'm demoing the MX250 in my environment. I have a special situation that requires me to PAT 2 of my internal VLANs to 1 external public IP address. I do this easily with my ASA firewall, but can't figure out how to do ...
My wildcard certificates were recently revoked because 2 duplicate certificates were created with underscores which aren't allowed, so ALL my certs were revoked.
I cannot access my FMC through a browser. Does anyone know how to remove the certific...
Thanks, but that did not work. I also tried to clear xlate, but the route-map Edge never gets called. The InsideDevice completely bypasses that and goes out the default connection.
Thanks for the quick reply, Rob. That's the way I used to do it with my ASA's. But, with the FMC and the firewalls being in a HA-PAIR, I can't individually select the separate devices, it's both or none.
