Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello -Our ITC purchased a new Cisco 7326 Wide Area Application Engine equipped with three 300GB hard drives and ACNS version 5.5. We intend to utilize this applicance as a cache engine only.The 7326 will connect to our Cisco 7206 BGP Router and Cis...
Per Cisco TAC:There is a limit of 64 Gig of CFS data per disk on the WAE-7326 ACNS system. If you would like to use more CFS caching on the box, you can replace the large disk with several smaller disks.This design was meant to optimize the performa...
F.Y.I.Cisco's WAE-7326 is limited to caching 64Gig per 300Gig drive so six 300Gig drives (max 6 drives) equals only 384Gig total caching capacity. Check it out with Cisco TAC.
Check out IronPort's S650 for caching:http://www.ironport.com/products/ironport_s650.htmlIronPort was recently acquired by Cisco.http://www.ironport.com/company/ironport_pr_2007-06-25.htmlhttp://newsroom.cisco.com/dlls/2007/prod_062507.htmlhttp://www...
Hello ...You can use the Multilink command to create a vitual interface bonding multiple T1s.!interface Multilink1 description Test Site ip address 10.xxx.xx.x xxx.xxx.xxxx.xxxx no cdp enable ppp multilink no ppp multilink fragmentation multilink-gro...
