Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently using WLC 4402 with about a dozen WAPs. I would like to start logging some messages to troubleshoot some association issues. The syslog does not seem adequate for this the issues I am having. I noticed the default SNMP traps but is only ...
this is a repost, sorry if it appears twiceWhat is the type and IOS version of the L3switch your WLC4402 is connected to?I think you are onto something with your debug. The fact that your wired client can get an IP address, but cannot ping the egres...
Your interfaces are interesting. I thought I remembered reading somewhere that the ap-manager and management interface should be on the same subnet. Did you transpose the wireless interface IP address and management interface IP address? Check out...
Armonk-Sounds like you have it right.I am curious. If you are using the same interface for wireless and wired egress, and they get DHCP from the same place, does wireless allow you to ping to vlan gateway but wired does not?They way I understand it,...
Armonk-I am using an L3 switch as well, you are correct it should make no difference.Looking at my config, since I am using trunking (dot1q), both my wireless (egress) and wired (ingress) are available to the switchport connected to the controller. ...
Armonk-Our WLC 4402 is running version 5.0.148.0.I have LAG turned on, but I am not using it (only one port is connected). From what I understand LAG is similar to Etherchannel (port aggregation/redundancy). The trunking I setup was for VLANs. I ...
