Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have installed / configured WLAN 2106, connected first AP (1100), all is well. I can get into the management console and see that the AP is up, etc. However, when I pull out a laptop and try to connect to the network, I am told that the laptop needs...
I got into the WLAN tab and enabled both Static Wep and MAC Filtering. Then went to the Security tab and entered the MAC address of my first laptop. Fired it up and it does not see the wireless network, which is not good. Am now trying to take off...
Sorry, I wasn't clear. I *may* have an answer to *some* of this, at this point. The difficulty I am having is in allowing wireless clients to connect to the AP. I'm doing fine in terms of getting to the GUI and navigating the various menus there. ...
