We are replacing this appliance and I want to clean all our specific information off of the appliance. Restore it back to factory defaults.I tried the "application reset-config" command, but that tell my it's not valid in this version NCS?How can I ...
I have an admin rights but still cannot login to the CLI prompt? My problem being I cannot remember the root CLI password. Can you only login to the CLI with the root account? Is it safe to reboot the NCS unit, will if drop all of the wireless clie...
Even thought it is configured and showing on both the NCS and the WLC, it is still pulling a DHCP address from somewhere?Where is it getting this from and how to your clear it and make it take the static IP?Thanks, Tandrist
I am trying to upgrade/migrate my WCS license file, via XML export, through the Cisco licensing portal and I keep getting the error listed above.Has anyone else ran into this? What the heck am I missing here??Thanks, Tandrist
Some maps are not showing connected clients. Getting warning message saying MAP has not been assigned to any Mobility Service yet. Where do I set this? I have compared my working maps with other building maps and do not see any differences in conf...
I found the reason that the logs are not saving past 7 days. It was and issue with WCS version 4.2.62, according to what I was told by Cisco Support. This was corrected in Version 6, which we plan to upgrade to in the near future.Thanks for your int...