Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am still running 2.0.4.2. Had a lot of problems with the WAP4410N AP's, but I discovered that when I turned off the checkbox "Allow wireless signal to be repeated by a repeater" (and so disabled WDS) the AP's are working very well. My first set-up ...
Cisco support recommended me to use a switch that supports STP (Spanning Tree Protocol). I purchased a HP V1910-16G and enabled the option. Now I have to wait to see if the network stays stable.
I also experienced this issue after upgrading the firmware to 2.0.4.2. The solution was to reset the AP to factory settings. Maybe that you can backup and restore the configuration, but I don't know this for sure. I think the best thing that you can ...
I contacted Cisco support and the (very helpfull) engineer asked me to make a Wireshark capture. It seems that as soon as the "Allow wireless signal to be repeated by a repeater" is enabled, all devices on my network begin to broadcast, which results...
