Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone..I am a complete newbie to Cisco equipment. So far I've been able to figure out how to do most of what I needed by using the ASDM but I have run into something that is a little more complicated that just opening a port.We currently have a...
Hi Mitchell..One more question if you don't mind.I am at the remote location and everything seems to be working very well.One exception.I have a dns entry to allow inside machines to access our forward facing web site by using the internal IP.That ha...
Hi Mitchell...No worries.. It's just something I was curious about.Ok, I do have one more question though. The 5505 is running an old ASA version - 8.0.The newest version is 8.4.4ED. Should I install this version or should I just leave well enough al...
Hi Mitchell..You rock!After removing the VPN entries on both ends I was able to ping machines from either network.I added the NAT statement above and now the remote location has internet access.I am curious though.. I disabled the VPN connections on...
Update:From inside the 5505, I can ping random 10.0.0.0/16 addresses inside the Mount Vernon network. Except for 10.0.1.1 which is the 5510 gateway IP. Which is to be expected I suppose.But I can't ping 10.0.0.0/16 addresses from the 10.3.0.0/16 netw...
Hi Mitchell..Thanks for your reply... Configs pasted below:-----------------------Main Location ASA5510 Configuration FileAll references to Mabton public IPs have been changed to 5.5.5.5All references to MountVernon public IPs have been changed to 7...