Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking to do P2P Tunnel from 2 Cisco 3620's. What is the latest IOS IPSEC Version and short command structure for this? If I remember correctly it was only a few lines of configuration to get this up and running.
Is there a particular software revision I will need on my Cisco 3620's and 3640's in order to get them to function with the IDS 4210? Or does the IDS do all that for me? I haven't tarted the IDS up yet so I am new to this.
Use a loopback address. Then do the static nt overload command for it such as:ip nat inside source static tcp 23 1.2.3.4 23 overloadThen from the outside you will be able to telnet and it is somewhat more secure too.
