About etf1

etf1 · 08-16-2007

Question, I have a 3560 switch with 1 G0/0 enabled, 1 serial port with a subinterface. I have configure the both ports and the default gateway yet, when I do a sh ip route I received the following error Default-Gateway not set. I've even tried to use...

etf1 · 08-20-2007

Will do and I'll let you know..Thanks

etf1 · 08-20-2007

Thanks for you asistance on this...I appreciated your comments... Always good to have someone jump in.. I'll let you know when I can get this back online to test..Again Thanks.........Ernest

etf1 · 08-20-2007

Ok, That may be it... I hope so however, I never tested or tried the sho ip route command on a box that was/is not physically connected to anything. Which started me asking why the Gateway would not set? That would hold true of a layer one issue.Howe...

etf1 · 08-20-2007

I made the change on both S0/0/0 and s0/0/0.1 "No shutdown" however, It's still has the "Gateway not set message".Note: there is currently no connection to the serial port... I'm in and out via hyperterminal

etf1 · 08-20-2007

Not sure myself, Note: I have 30 additional "2851" on my einterprise with the same basic configuration without this issue?Show ProtocalGlobal values: Internet Protocol routing is enabledGigabitEthernet0/0 is up, line protocol is down Internet addre...

Member Since	‎08-16-2007 07:56 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	10

User Statistics

User Activity

Default-Gateway -not-set?

Re: Default-Gateway -not-set?

Re: Default-Gateway -not-set?

Re: Default-Gateway -not-set?

Re: Default-Gateway -not-set?

Re: Default-Gateway -not-set?