Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to set up a L2TP remote access for native windows clients on our Cisco 1811. The tunnel builds without any problem but the client can access only the router via the VPN. There is no access to LAN. Please help.
I have a cisco PIX 515E upgraded to the latest 8.0(3) software. I am using a VPN configuration for native Windows clients using L2TP and certificates. Windows XP and 2000 clients can connect normally, but VISTA does't connect at all. I made the follo...
Hello,I have a problem with VPN configuration of our PIX Firewall.We use this configuration:PIX 515E (3 interfaces) running the latest 8.0(3) firmware.We are using an L2TP IPSec VPN with certificates from our Microsoft CA and using the native Windows...
I am a bit confused. Are you trying to make a L2TP connection to the PIX or through the PIX to another server? If you want to connect with L2TP to the PIX, these commands are necessary.
No problem. I deleted the IP Addresses and changed domain names. I did most of the config using the WWW interface, later I did some finetuning with the command line. If you need futher help, just ask.
I have exactly the same problem, but I was unable to find a solution yet. My router is 1811 and has 384 MB RAM, so I think that memory is no issue. Any help?
