Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a strange problem and need to know the best way to diagnose its cause.I have a remote site where I originally had a PIX 506e installed. It worked well with one exception, occasionally it outside interface would stop responding. A reboot would ...
I am looking for the correct placement of WAE 512 appliances. I have a data center where WAAS Central Manager and WAE 512 Core appliances will be installed. The Data center will be set up as follows:1841 rtr xover to PIX515e xover to WAAS Core strait...
I am having the exact same issue. My HQ has 2 ASA 5520's standby failover mode. The remote site that gets sick is an ASA 5505. It is on 7.2 (3) and HQ is on 8.0 (3). No other sites have this issue and I have lots of them running all sorts of IOS with...
In my case the behavior was the same as you discribe. Nothing appeared in the logs and I was stumped and thought for sure the issue was the ASA 5505. However, I contacted the ISP who managed the router, and the indicated that the inside interface of ...
The issue I'm having on my outside interface of my asa5505 is not related to the ASA it seems. It is located in a remote site and I have contacted the ISP who manages an Cisco 1841 router that the ASA is connected to via cross over cable. They asked ...
Did you ever find out what was wrong? I have a similar problem on my outside interface. I'm collecting logs but nothing was revealed in them that would explain it.
They are still up. Some tunnels were intermittently up and one was up all the time of the 15. I have noticed that they can grow stale and I believe there is a command to fix that as well, I just don't remember what it is.
