Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My company has three PIX 506e which do a site-to-site VPN. It works great. We are looking at replacing one of the PIX, due to a bad fan. Whereas PIX is EOL soon, we are looking at the ASA 5500 series. Which one will work will our current setup?So...
We have a site to site VPN set up using the PIX 506e. The IKE and IPSec tunnel set up and work great; TCP and ICMP traffic flows through them wonderfully! UDP traffic, however, is a different story.On the "far" end, we have software that sends a UD...
Thank you for your response, Jon.What is the best way to upgrade our current PIX devices to v7 or v8? We don't have a current support plan through Cisco or a vendor, but I imagine that we would need to purchase one to do that.Would that be recommend...
The command which enabled nat-traversal with a 20 second keep alive for me:isakmp nat-traversal 20I am running a PIX 506e firewall.As far as I know (which isn't much), it does have to enable it for all your clients, but I don't have any reports of it...
Had a similar problem as the individual above: I could take a laptop and connect for hours at some places, but other places would only stay connected for a few minutes before disconnecting. It was probably the issue of whether I was going through a ...
Jon,No worries. Talk about an obscure problem!Thanks for all your help and willingness. I was surprised at the quickness of the response.Thanks again.Willie
