Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When a server starts sending the file, i see a random port being used. Now how are we supposed to write a proper ACL for this...accept everything from the host? Modify the tftp server source code?Please help.
Hello, Im looking forward to dropping a user in the appropriate vlan after the eap processing is complete by ACS.Does filter-id property mean vlan in acs? Wait, i think thats ACL. What property is vlan?About the vlans, how do i specify them on the sw...
Hello, without an access list, OSPF works fine. I then tried the followingaccess-list 100 permit ospf 172.16.16.0 0.0.0.7 host 172.16.16.1int e0ip access-group 100 inWith the access list on the interface, OSPF does not work. With it off, OSPF works ...
From rommon, do the followingset command for variables - ESPECIALLYset TFTP_CHECKSUM=0Also, make sure to fill in your ip, gw, mask, tftp server, tftp file with the set commandNow, issue tftpdnld
Upon boot, send a break to hyper terminal (maybe ctrl+brk). You will be dumped into rom monitor.Enter "?" - you should see commands available. Use the config-register command, and set it to 0x2142The router will boot with no configuration. However, y...
Replying to my message is a bit silly, but as i look at my syslog (which is still not showing unicast), i seeDENY: 172.16.16.2 -> 224.0.0.5Looks like i need an entry for "all ospf routers"
