Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I understand that there are three types of traffic in a switch enviroment:-Control Traffic (i.e. CDP, VTP always use VLAN 1)-Management Traffic (i.e. telnet, snmp -Vlan 100)-End user traffic (all of the remaining traffic - i.e. Vlans 10, 20, 30)I un...
How can I force a 2960 switch to use the default gateway parameter.?I try with the command :ip defautl-gateway 10.10.10.1but the switch never use it.Thanks in advanced
Im configuring 802.1x user authentication in the 2960 edge switch using a Radius server located in other subnet. The core is compose with two 3750 L3 switches running HSRP redundancy. So is very important to force the 2960 edge switch to use the defa...
Hi Mohammed,Thanks for your answer,I have another question related:By default the 1242 APs must be configure with the management vlan as a native vlan.It's possible to configure a Management vlan in the Access Point 1242 different than the Native Vla...
Im configuring 802.1x user authentication in the 2960 edge switch using a Radius server located in other subnet.The core is compose with two 3750 L3 switches running HSRP redundancy.So is very important to force the 2960 edge switch to use the defaul...
By default 2960 switches never uses theIP default-gateway parameter in order to reach remote networks.The switches just send an ARP request with the destiantion IP.So, I want to force the 2960 switch to use the parameter as a normal client IP use the...
