Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning to all of you,I have a strange problem with our Cisco 2801 Router in a Intranet with 3Com 4200G Switch. The router is connected via F0/0 to the 3Com Switch and via F0/1 to a HP 5304XL. The transfer from F0/1 to F0/0 is fine. 90% network ...
cisco2801#sh int f0/0FastEthernet0/0 is up, line protocol is up Hardware is Gt96k FE, address is 001a.a1f3.ee1a (bia 001a.a1f3.ee1a) Description: $ETH-SW-LAUNCH$$INTF-INFO-FE 0$$FW_INSIDE$$ETH-LAN$ Internet address is 192.168.4.140/24 MTU 1500 by...
ok, let's check.srv1 -- netgear -- cisco -- hp -- srv2 this works fine from both sides.srv1 -- 3com -- cisco -- hp -- srv2 this only from srv2 --> srv1the other way 10-20%
Hi,srv1 -- 3com -- netgear -- cisco -- hp -- srv2nothing changessrv1 -- netgear -- cisco -- hp -- srv2works fine from both sidessrv1 -- hp -- cisco -- hp -- srv2works fine from srv2 --> srv1but little bit slower the other waysrv1 -- 3com -- cisco -- ...
