About farahs123456

farahs123456 · 10-24-2007

Hello,I have a few newbie questions regarding vlans and limiting access.1. How can I assing the 2 onboard FastEthernet ports on a 2811 to separate VLANs?2. In the absence of being able to assign these two ports to VLANs, I am trying to assign differe...

farahs123456 · 10-24-2007

My 2811 every so often after a power cycle just sits there with the SYS PWR LED flashing. A console shows the rommon> prompt. So it appears to be sitting in the rom monitor mode rather than booting up. If I power cycle again then it boots up fine. ...

farahs123456 · 10-24-2007

Hi,I am a newbie to Cisco routers and have a basic question:I am using a dhcp pool to assign DHCP addresses to clients. The DHCP clients also automatically get assigned the DNS server by the router and DNS resolution works fine. However if I have a...

farahs123456 · 09-11-2007

I have a simple LAN with a few client PCs running standard windows VPN client software that need to connect to an external VPN server through a 2811 router which is on my LAN. In order for VPN pass through to work through this 2811 router, does it n...

farahs123456 · 10-25-2007

Thanks Sundar. That answers my question.

farahs123456 · 10-24-2007

Rick,I want to use the same DNS for both DHCP and static clients as I agree it makes no sense to have different DNS servers for the two. I have two options it seems for configuring DNS for static clients:1. Specify the DNS servers on the static clien...

farahs123456 · 10-24-2007

Thanks a lot Saro. I guess I was defining the access lists but not really using them. Adding that that to the interface as you suggested did the trick.

farahs123456 · 10-24-2007

Thanks for your response Rick. So lets say my router is 192.168.1.1. In the setup of the static clients I will be using 192.168.1.1 as the gateway but should I be using the actual DNS server addresses for the DNS and not the router address here? I...

farahs123456 · 09-11-2007

Thanks a lot for clarifying that Sundar. Speaking to Cisco I was a little confused about this because they were saying that I would need the advanced security IOS. I am guessing that is probably the case if the router itself is the VPN endpoint whi...

Member Since	‎09-11-2007 02:11 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	9

User Statistics

User Activity

vlan / access

Cisco 2811 rom monitor mode

DNS for clients using static IP addresses

VPN pass through with 2811 / IOS

Re: DNS for clients using static IP addresses

Re: DNS for clients using static IP addresses

Re: vlan / access

Re: DNS for clients using static IP addresses

Re: VPN pass through with 2811 / IOS