Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do I add the call pickup softkey to a 7905 on the CCME platform? I also need to add a softkey for speed dials to a 7940 and 7905.Has anyone out there done these?
Has anyone had success using the Attendant Console over Terminal Services? The Terminal server is NOT the Call Manager, but a separate application server. He will need about 4 attendants using different user sessions of terminal server. This is also ...
We've licensed 35 VMI seats for our client. Under licensing, we show that there are 35 seats listed as Cisco Unity Inbox Subscribers. Whenever I go to <ip address>/web/ciscopca or <ip address>/web/vmi, I get page not found. I looked in the IIS manage...
I've just set up a 7920 on a 1200 series access point. I get "authentication OK", but then the message "No Service - IP Config failed." Has anyone else seen this error? I disabled TKIP and MMH on the VLAN the phone uses, since when I had them on I go...
I have 5 sites connected with fiber on a small campus. Each site will have a 1760 router for SRST and local 911. When users dial an outside number, they will sieze a trunk at the main location. When they dial 911, the call needs to route through thei...
I was able to get the phone to register with the CCM, but I have to disable WEP and set the IP static.I looked at the firmware rev. and it reads:7920.3.2-01-00Does this mean it's verion 1.00?TIADavid
Thanks for your reply! I actually found that disabling the file cache on the TFTP server solved the problem. I got the idea from another post that described a problem with rings, for which the TFTP cache was the problem.Thanks again!David
Are you saying that the G729 timeslots are nailed down on the interface or across the link?Also, this is a frame connection (512k). Is there an MTU concern with regard to the signalling channel? We are using a fragmentation and interleave configurati...
Pressing pickup is fine if a single phone is ringing, but that's not usually the case. This is not personal, but that's a typical Cisco-style response; buy more hardware to get just half-way to a standard PBX feature. This is a common feature that sh...
