Hi everyone! I am wondering anyone knows of a good design document or a list of pros and cons available when deciding to use Point-to-Point or the default (multipoint inverse ARP) configuration on Frame Relay networks?
you can setup a 30 bit address on both of these interfaces and make sire EIGRP is setup for no auto-summary. Setup load balancing and when one DLCI goes down then the other one will be ready anyway! If for some reason you would really rather not ha...
try performing a "show controllers serial x" command and do an output comparision between another router's controllers output. Also, check the cable and try to replace it. An interesting fact is that the max capability of a serial interface is 2MBi...
if I am not mistaken, this is a routing protocol based issue. If you are running EIGRP for example, it will not form adjacency using the secondary address even though it might advertise it...
A ping to a non-existing station would usually go to a default route. How is your routing and load defined to bring the bridge up (sorry not to familier with x.21). If you have a router defined for the other side of the link (or snapshot route), th...
Sorry that was three columns with the courier font. 1) Configuration Type 2) MultiPoint 3) Point to Point and then I compared the features on the left with the availibility as yes/no on the right two columns.
