Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
Is there a way to log all cli command without TACACS server on IOS-XR (like "archive config" in IOS/IOS-XE) ?
I know that "show cli history detail" can print all command, but I wand to store them in log and to external syslog server.
Th...
Hi everyone,I am looking for a way to use a 3G connexion on ASR1000.Is it possible to install HWIC module of ISR2 in SPA slot or use an USB modem on the RP?Thanks in advance for your reply.
Hi everyone,I have a question about the ouput of "show ip route" command. Sometimes, prefixes are shown in two lines like this :i L2 172.30.112.0/21 [115/10] via 192.168.255.11, 1w0d, GigabitEthernet0/0/0.11i L2 172.30.120.0/21 ...
Hi everyone,I have some questions about CBWFQ/LLQ :As explain in many cisco press book, CBWFQ determine preference between classes on weight (derived from bandwidth command given to each class-map). So, packets in a class with a higher bandwidth wil...
Hello,First, I want to tell you that I realy appreciated your return and answers about this platform. I have two questions :- The first is about QoS. When reading this document, it seems to be planned to support "min bandwith percent propagation" and...
Thanks, I already know this command,I would filter the output to have just one line per prefixe like this :i L2 172.30.112.0/21 [115/10] via 192.168.255.11, 1w0d, GigabitEthernet0/0/0.11i L2 172.30.120.0/21 [115/10] via 192.168.255.12, 1w0d, ...
I admit that your comments made me doubt compared to informations that I could read in the past. After some research, I found this information from the book "Cisco Telepresence foundamental" editing on 2009 :CBWFQ allows for the creation of up to ...
Hello,I know that is possible on 6500 platform (SUP32 and 720). This feature is called UBRL (User Based Rate Limiting) or Microflow Policing. It allows you to provide a certain amount of bandwidth to users (bases on src or dst IP address) ...
