Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am in the process of testing VA5(1.2) version of ACE on ACE4710 appliance.I did redundnacy configuration and it is working fine.I have done the snmp configuration and SNMP trap receiver is able to recieve traps like link up/down, so it proves th...
Hi All,Need help for below queries.What are the maximum number of real servers, server farms and virtual servers i can configure on ACE30 module? Is there any documentation available on cisco site where i can check this?Does it depend on the hardware...
Hi,I am in the process of configuring load balancing on ACE module but struggling to configure virtual IP address for ACE module.I'm working on ACE30 module and using software version A5 (1.2). ACE module is in slot of Catalyst 6504 switch.Can anybod...
Hi,I'm using version A5 (1.2).I could find most of the details but still struggling to find out the maximum number of virtual servers or number of virtual IPs that ACE30 modue with A5 (1.2) can support.Regards,Rachit.
Hi Cesar,Thanks.Is NAT really mandatory for this configuration to work?I removed "nat-pool 1 10.198.16.122 10.198.16.122 netmask 255.255.255.192 pat" configuration from interface and removed "nat dynamic 1 vlan 112" from policy-map but then loadbalan...
Hi Cesar,Many thanks for your reply.I did the configuration and it is working (may be parially) now. I still have few questions so if you can help please.1) I did not have aby Virtual IP configured for ACE30 module on which i am working on. Is follow...
