Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am facing SSH connection failure between a source and destination using Public IPs over internet, It seems SSH traffic is blocked somewhere in the middle. Tried to telnet destination IP on port 22 but fails, while with some other TCP ports it's suc...
https://community.cisco.com/t5/routing/tracking-in-a-route-map/td-p/3898975Reference to the discussion in the above link (btw its a very old discussion, that's why I decided to create a new one with reference), can someone please help me the work aro...
Hello Experts,I have two CE routers from two ISPs with default static routes towards their respective ISP gateways for internet, and OSPF between the the two CE routers and a layer 3 core switch which is injecting default route with equal cost for lo...
We have two edge routers from two ISPs with static default routes for internet, both the routers are connected to a layer 3 switch. Currently we have configured HSRP between two routers with default route in the switch towards the virtual IP to achie...
Hello Experts, Any idea on how to address the subject vulnerability is cisco routers, where I have observed the routers with latest recommended software were also affected.
Thank you for your reply, yes ssh is enabled on the destination device and there’s no ACL blocking it. For the second question, destination is not behind NAT, source host is port forwarded for ssh.
@MHM Cisco World My bad, sorry for being a noob. Its working as expected, load sharing when the destinations are different, which I haven't tried earlier, now I see taking different paths upon tracing different destinations. I haven't focused when yo...
Thank you, but still I couldn't get through
Ip cef load-sharing per-packet
command
Switch(config)#ip cef load-sharing ?algorithm Per-destination load sharing algorithm selectionkey-control Configure algorithm control valuesSwitch(config)#ip cef load-...
