Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiHave a 515E PIX with a "Internet" ip range for both the outside and DMZ interface.I'm having a problem when I specify and access list to allow the mail relay to forward mail to the internal mail server.This is my configfixup protocol smtp 25access-...
I want to double check the following. On an interface that does NAT, access-list and firewall, what IP to block? NAT or NATed?interface Serial0.500 point-to-point ip address xxx ip nat outside no arp frame-relay no cdp enable frame-relay interface-dl...
HiWe have some problems dialing in remotely.Here are some debug:Any ideas?6d13h: ISDN BR1/0: Recvd MPH_IIC_IND from L16d13h: ISDN BR1/0: L1 is IF_ACTIVE6d13h: ISDN BR1/0 EVENT: isdn_sw_cstate: State = 4, Old State = 46d13h: ISDN BR1/0: Incoming call ...
Hiwe have another company trying to connect to us. they use netgateway on aixThis is their config, then follow our config. isdn debug at the endThey dial in and the connection is immediately disconnected.Any ideafrom netgw config isdn_IMCAM { ...
I'm trying to find a solution and is still very much in the dark.We have a pc with IP 192.168.100.100 connected to a router with IP 192.168.100.6. On this router is another interface 192.168.106.6. Behind this interface is the bloomberg network we co...
