Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to use a PC Dos based sniffer server from Network General(Network Associates)in my network.I'm new to this product..the issue is that when i boot up the server it allows me to configure the interfaces but after that it doesn't go to t...
Hi,has anybody used MRTG to monitor a DS-3 link..I tried using it but i don't get graphs for the traffic on the DS-3 interface.MRTG says that since its a DS-3 controller its unable to plot the graph.Any help is appreciated.regards,jimmy.
Hi ,What should be the ideal CPU utilisation for a 3640 router with 128 MB main memmroy and 16 MB flash? The output of sh process cpu is CPU utilization for five seconds: 50%/16%; one minute: 35%; five minutes: 32% Which utilisation should one be ll...
Hi ,My branch office network with workstations is contacting my DHCP server in datacenter across a T1 link for getting their IP addresses.I've enabled forwarding of DHCP request from client network router using IP helper address. By default when i u...
Hi,I'm trying to run EIGRP between two 3662 conected using an DS3 link terminated over NM-1A-T3 modules on both routers. The DS3 circuit is upand I'mable to ping/telnet between the routers, but EIGR neighbour relations does not formbetween the router...
Hi,I know that the main reason for my router CPU utilisation is VPNs but what i would like to know is 1. Can i consider an average utilisation of 45% as normal2. What should be the ideal utilisation for this router3. Is there any document or URL avai...
Hi,The processess consuming the CPU areCPU utilization for five seconds: 39%/11%; one minute: 55%; five minutes: 53% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 30 81099912 147061877 551 7.20% 8.61% 7.16% 0 IP Inpu...
