Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have a central switch (CAt4k6) with a Flat network .The workstations ping each other at <10ms but the NT Login takes place fter 2 attempts. What can be possible issues ?Regds/-Kaustav
Hi, We have a CISCO 2651 multihomed to 2 different ISP 's for Internet access. We find that the Serial 0/1 of bandwidth 256 Kbps of the WIC -2T shows CRC errors constantly increasing with the reliability decreasing. The Service provider says that ...
I have a multihomed router connected to 2 different ISPs and would like to allow outside users to access some servers in the inside LAN. These servers have valid IP address which I want to statically map to private addresses and allow internal users ...
Scenario: 1.Multihomed router having Serial 0 and 1 terminated into 2 diferent ISP 1 AND 2(1 for Failover). FastEthernet 1 and FastEthernet 2 has 2 different valid IP addresses A.B.C.D and M.N.O.P. We have to connect the PIX Firewall with only one Fa...
I have a stack of 3500XL of 5 switches and daisy chained to each other.They have been configured in a single VTP domain and 7 VLANS spread in the 5 switches.Will the uplinked ports be configured as trunks using dot1q or isl for VTP messages to travel...
Hi, I had installed a Cisco 801 for internet access . The problem is that I configured with NAT overload and all the dialer profiles were configured. I have configured for DDR and only I have to do is telnet it and check the ISDN status. If it sis...
