Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been having a recurring, intermittant problem with DHCP-assigned IP addresses not getting assigned to Aironet 350 equipped Compaq iPAQ PDAs. I've upgraded the card (4.25.23) & AP (11.10T) firmware to the latest versions. iPAQ client software i...
He's right, it's only there to combat the effects of multipath. However, multipath interference isn't always rare. Installations with a lot of metal can cause reflections which contribute to multiple paths. Best bet, try it both ways and look at y...
Check out Funk Software's Odessey Client (www.funk.com) or the 802.1x Supplicant at http://www.mtghouse.com/supplicant_priv.htmlLet us know how these work. They advertise support for Cisco and Lucent NICs.Regards,Mark
I have not done this yet (we currently use ACS 3.0), but am interested in learning if it will work.I'm worried that MS RADIUS does not provide the Cisco-Proprietary (LEAP) authentication protocol that your client uses. But I guess you could be using...
Here are my thoughts:(1) I've always thought it was a 'max. power possible' percentage, but I hope to hear other comments about this. 20 dBm/100mw is the max. TRANSMIT power, though, so the "maximum" would likely be based on a recieved signal streng...
I too would like to see RF-style (dBm, SNR, etc.) readouts in the PDA software. I use the Compaq iPAQ for site surveys. We're just completing a 300K sq. feet building. It sure beats lugging around a laptop.Make sure you use the FAST PSP power save...
