Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have an issue where I would like someone else's take on things..
Basically we have a managed MPLS network by a third party so we have no insight into their PE kit config which makes this a little harder to understand, but I will try and gi...
After reading some info on Julio's website, I have come to think my VPN configs are a bit too fat and not very streamline. My configs are starting to hammer CPU on the routers now, especially as the remote offices are now starting to use VDSL speeds....
Hi all,I have a problem with getting port forward to work. Does this config look right?Basically I want to forward all traffic from ports UDP 88 to internal 192.168.10.210, TCP & UDP 3074 also to internal 192.168.10.210Also port TCP & UDP 32400 to in...
Hi David,
Thanks for the response and diagram.
Actually tested this OK yesterday by changing the link from the PE to Nexus as IP to IP not using a VLAN and also another IP to IP from Nexus to NAT.
I understand why it was done this way as the dual li...
Hi David..
There is not packet loss when accessing/pinging from the nexus to anywhere. Only when coming from the remote sites.. my packet captures are showing successful pings following the path of:
PSBA kit -> Nexus VLAN
Nexus VLAN -> NAT Device...
Hi Julio,Nice one on fixing the problem.Still cant see why traffic has to be treated the same way on out and in, thought if the inspect is set to allow the traffic in, then permitting without inspect on the way out just seems to make sense if the tra...
Sorry for the delay, but here is a running config.. Thanks.Current configuration : 6877 bytes!version 12.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecservice password-encryption!hostname!boot-start-markerb...
