Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,
I am try for AP to join controller.Its not passing the join phase.
AP is brand new AP (3802I) and controller is 5520 software version is 8.2
I am seeing discovery response sent after that its throwing below error
*spamApTask5: Nov 18 13:56:59....
If you are referring to add AP mac address in AP Authorization List of AP polices in WLC, then yes, I tried doing it.
But no luck. still AP stuck in join state
Hi, even I am facing same issue
Ap is getting IP throu DHCP on switch.IP is pingable from controller
but I am trying for AP to join controller.Its not passing the join phase.
AP is brand new AP (3802I) and controller is 5520 software version is 8.2...
Hi,
even I am facing the same issue.
Ap is getting IP from DHCP on switch. IP is pingable from controller
am try for AP to join controller. Its not passing the join phase.
AP is brand new AP (3802I) and controller is 5520 software version is 8.2
I ...
